Can anyone tell me why I can not get into the CIC module? everything else works fine.After you select chassis (e89), press F1. So I connected and stuff but when I press F1 it asks me to enter my VIN?Īfter you load FSW PSW MAN, press F2 to load chassis (e89). Reference this INPA FAQ | MediaFire Mirror | Update: Ok, technically the FIFO options still exist.but in registry, reference this post.
Ncs expert revtor drivers#
If you decide to get the drivers straight from FTDI, reference this post for some clarification. The newer FTDI drivers do not have this feature. FIFO must be enabled? Tx and Rx set to "8"? The hell is this, I don't have these options in my COM settings?.The ones in "\EDIABAS\Hardware\OBD\USB2.0 Win XP" will not work because you are essentially using a third party cable. Make sure you are using the correct drivers. Ummm I'm getting a communication error?.Also make sure you are using INPALOAD.EXE. Many who could not get it to work just skip this preliminary step. Why does xxxjecxxx insist on the airbag test in INPA before NCSEXPERT? I can't get it to work, I'm stuck!.
Ncs expert revtor pdf#
Your R&D is truly appreciated.įollow xxxjecxxx's PDF guide. Reference the original thread if you have any further questions thanks to xxxjecxxx and the community for laying all the ground work so it's easy peasy for the rest of us. (edit: this is a joke, Windows 7 and Vista share very similar architecture.except Vista sucks) Windows 7 compatibility confirmed-XP compatability mode not required.圆4: there is driver support but programs may not work properly-YMMV Choosing a quality cable is important otherwise you will have intermittent connectivity and other connectivity issues.If you decide to purchase a different brand-YMMV: the Master thread and this FAQ assume the above-linked cable is purchased. What do I need to get started? Any laptop and a R232-OBD2 / USB-OBD2 Cable.Please help the community out by updating Neutrino45's spreadsheet whenever possible.